Migrating a project
3.5 Setting the address of the HMI device
Migration Guide Comfort Panels
38 Getting Started, 03/2011, A5E03478626-01
3.5 Setting the address of the HMI device
In WinCC flexible, an IP address set for an HMI device in the project was not transferred to
the HMI device.
As of WinCC V11, an IP address set in the project is assigned to the respective HMI device
during the transfer. You assign IP addresses for all HMI devices centrally in the "Devices &
Networks" editor:
A
As an alternative, you can still set the IP address using the Control Panel of the HMI device
or an DHCP server. In both cases, select the option "Get IP address another way" in WinCC.
To Next Page
Loading...
Need help?
General
