7. Open a Windows command prompt and change to the directory where the file with the new
firmware is located and then execute the following command :
tftp -i <IP address> put <firmware file>
Note
You can enable TFTP in Microsoft Windows as follows:
"Control Panel" > "Programs and Features" > "Turn Windows features on or off" > "TFTP
Client".
8. Once the firmware has been transferred completely to the device and validated, there is an
automatic restart on the device. This may take several minutes.
Upkeep and maintenance
7.1 Downloading new firmware using TFTP without WBM and CLI
SCALANCE XB-200
46 Operating Instructions, 03/2020, C79000-G8976-C359-09
To Next Page
Loading...
Need help?
General