Siemens SINUMERIK 840D sl Diagnostics Guide

4-973
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Error Codes of Alarm 300500 4
After the error codes 1 listed below an error code 2 may be specified. This must
be interpreted as the hexadecimal number of the terminal block/module.
Error code 0001H
Error text Error in P:-RAM
Extension 1
-
Extension 2 Incorrect address
Explanation When the program memory was being tested during power-up, it was detected that the
written bitmap could not be read back.
Cause: Hardware error on control module.
Error only occurs with drive software V1.x (EPROM version). The error has been
replaced by system errors F034 and F035 in subsequent download versions.
Remedy Replace the control module
Error code 0002H
Error text Error in X: or Y:-RAM
Extension 1
-
Extension 2 Incorrect address
Explanation When the data memory was being tested during power-up, it was detected that the writ-
ten bitmap could not be read back.
Cause: Hardware error on control module.
Remedy Replace the control module

Siemens SINUMERIK 840D sl Specifications

General

Control Type	CNC
Number of Axes	Up to 31
Max Number of Channels	10
Interfaces	Ethernet, PROFIBUS, PROFINET, USB
Interpolation	5-axis interpolation
Operating Temperature	0°C to 45°C
Relative Humidity	Up to 95% (non-condensing)
Display	TFT color display, various sizes
Programming Languages	DIN/ISO
Safety Features	Safety Integrated
PLC	Integrated PLC S7-300
Drive Interface	SINAMICS S120
Data Storage	CF card, USB
Operating System	Windows-based