en Installation and connection
40
Transportation
Empty the dishwasher and secure loose
parts.
Drain the appliance according
to the following steps:
1. Turn on the tap.
2. Close the door.
3. Switch on ON/OFF switch (.
4. Select programme with the highest
temperature.
5. Press START button @.
Programme sequence starts.
6. After approx. 4 minutes press
the START button @ until all
displays go out.
After approx. 1 min. the appliance is
completely drained.
7. Switch off ON/OFF switch (.
8. Turn off the tap, disconnect supply
hose and drain water.
Transport appliance upright only.
(This prevents residual water from
running into the machine control
and damaging the programme
sequence.)
Protection against frost
Protection against frost (Emptying the appliance)
If the appliance is in a room where there
is a risk of frost (e.g. holiday home),
empty the appliance completely (see
Transportation).
6XEMHFWWRFKDQ
HV
To Next Page
Loading...
Need help?
General
