■ 18
│
GB
│
IE
│
NI
│
CY
SEM 1100 B3
Cleaning the hot water shower
Clean the hot water shower . after each use:
1) After you have prepared the espresso/cappuccino and removed the sieve
holder 1, wipe the entire surface of the hot water shower . with a mois-
tened cloth to remove all powder residues.
2) Replace the sieve holder 1 without the espresso filters %+.
3) Place an empty cup under the sieve holder 1 and press the “Espresso”
button
down until it clicks in. Water flows out of the hot water shower .
rinsing out the remaining powder residue.
4) After about 20 seconds, press the “Espresso” button
again and
switch the appliance off with the On/Off switch .
5) Remove the sieve holder 1 again.
Cleaning the accessories
1) Clean the sieve holder 1, the two espresso sieves %+, water tank , the
measuring spoon , and the drip grille - in warm water.
NOTE
► If you put detergent into the water, it may effect the taste of the espresso.
If the stains can only be removed with detergent, always rinse the items
afterwards with lots of clean water.
2) Dry all parts well.
3) The drip tray 3 is suitable for cleaning in the dishwasher. However, always
remove the red float from the drip tray 3 before cleaning:
– To do this, remove the stoppers attached to the two retaining bars to the
side of the float.
– Pull the float from the retaining bars.
– Clean the float and stoppers.
– After cleaning the drip tray 3, push the cleaned float back onto the
retaining bars and replace the stoppers.
Cleaning the appliance
Clean the appliance with a moist cloth. If necessary, use a little detergent on the cloth.
Ensure that the appliance is completely dry before the next use.
To Next Page
Loading...
Need help?
General
