13 GB
Charging the battery
The battery must be charged prior to first use.
The LED
5
will flash red when the battery is drained. The battery
should then be charged as soon as possible.
Plug the micro-USB plug
12
on the charging cable into the micro-
USB socket
11
on the headphones! Plug the USB plug
13
on the
charging cable into the USB port on a PC or a USB adapter
(not included).
Note: The LED will flash red and blue whilst charging. Once the
battery is fully charged, the LED will remain blue.
Once charging has completed, remove the micro-USB plug from
the headphones.
Using the headphones
Connect the headphones with a communication device.
Place the headphones near a switched on communication device
(e.g. mobile or computer).
Pairing with a new Bluetooth
®
device: Hold the button
8
for approx. 6 seconds until the LED
5
flashes red and blue and
you hear two beeps. This indicates the headphones are now in
pairing mode, which remains active for 5 minutes. The head-
phones will switch off if they do not detect a Bluetooth
®
device to
connect to and sound 4 beeps.
Now connect your communication device (mobile phone or com-
puter) via Bluetooth
®
with the headphones. Please refer to the
notes in the instructions for your communication device. Select the
entry „HG00593“ from the list of devices detected by your com-
puter or mobile. If prompted, enter code „0000“ to establish the
connection.
To Next Page
Loading...
Need help?
General
