Silvercrest SBL 3 D2 User Manual

SilverCrest SBL 3 D2
30 – US-EN
Press and hold the button (1) for 2 seconds to switch off the
speaker. A tone sequence is output and “OFF” is shown on the
display (2).
The display (2) switches off after approx. 2 minutes if
no button is pressed.
9.2 Adjusting the volume
You can adjust the volume by briefly pressing the I◂◂ (8) or ▸▸I (4)
button. The currently set volume is shown on the display (2). An
acoustic signal sounds when the minimum or maximum volume is
reached. The speaker will always power on with the volume level
that was set when it was powered off.
9.3 Selecting a mode
You can switch through the modes by pressing the M button (9)
several times. The currently selected mode is indicated on the

Silvercrest SBL 3 D2 Specifications

General

Brand	Silvercrest
Model	SBL 3 D2
Category	Speakers
Language	English