- 10 -
• If you want to put the appliance down during
use, fold out the stands
9 to the front and place
the appliance on them. When you are ready to reu-
se the appliance, simply fold the stands 9 back
to the rear.
After using the steam brush
• Place the temperature regulator 3 at the position
"MIN".
• After use, ALWAYS remove the plug 7 from the
power socket.
• Pour away any water remaining in the water
tank 1 to do this, open, the water fill opening
2 of the water tank 1, turn the appliance upsi-
de down and lightly swivel it.
Cleaning and care
Risk of personal injury!
ALWAYS remove the plug 7 before cleaning the
appliance.
There is a risk of electric shock! Allow the appliance
to cool down. Risk of Burns!
Caution!
Never use aggressive cleansers. These can damage
the surfaces.
• Clean the housing with a soft, dry cloth only.
• Clean the metal components with a lightly water-
moistened cloth and a mild, non-aggressive cleaning
agent.
Scale removal
Should the steam output diminish over a period of
time, decalcify the steam brush.
• For decalcification use a standard commercial
descaling agent based on citric acid. Proceed
as detailed in the product instructions.
Storage
Attention!
Remove the plug 7 from the power socket and allow
the appliance to cool down before putting it into
storage.
Risk of fire!
Store the appliance at a dry location. You can also
hang the appliance up by the suspension eye 6.
Troubleshooting
The steam brush ejects no or very little steam:
The supply of water in the steam brush is exhausted.
Fill the water tank 1 with water (see "Filling with
water").
The steam brush does not heat itself up:
The appliance is not connected to mains power.
Insert the plug 7 into a wall power socket and
set the desired temperature with the temperature
regulator 3.
The steam brush is defective. Arrange for the ap-
pliance to be repaired by a qualified specialist.
The power socket is defective. Try another wall socket.
To Next Page
Loading...
Need help?
General
