Silvercrest SKG 1700 A2 User Manual

6
GB
could attack and soften the non-slip
plastic feet. If necessary, place a non-
slip mat under the device.
4. Items supplied
1 Contact grill with two grill plates
2 Grease drip trays
1 Set of operating instructions
5. How to use
FIRE HAZARD!
• Place the device on a dry, level, non-slip
and heat-resistant surface.
• The device must not be operated close
to flammable liquids or materials, or in
a potentially explosive environment.
Keep at a distance of at least 30 cm
from walls.
NOTE: when in operation for the first time,
some smoke and odour may be generated
by the device. This is related to materials
used on the heating elements during assem-
bly, and is not a defect with the product. En-
sure adequate ventilation.
• Remove all packing material.
• Check to ensure that all parts are pre-
sent and undamaged.
• Clean the device prior to its first
use! (see “Cleaning” on page 8)
1. Open the lid4 of the contact grill up-
wards. Be careful not to raise the lid
any further after it is vertical.
2. Before plugging in the device, check
that both thermostat controls9 +15
are set to the marking "•".
3. Insert the mains plug6 into a wall sock-
et corresponding to the specifications of
the rating plate. The power indica-
tor10 is illuminated as long as the de-
vice is connected to the power supply.
4. Rotate the thermostat controls9 +15 to
temperature setting 5. The device then
heats up the grill plates13, and the con-
trol lights1 and12 are illuminated.
5. Switch the device off after approx.
15 minutes by turning both thermostat
controls9 +15 to the marking "•".
6. Clean the appliance again. (see
“Cleaning” on page 8)
6. Operation
DANGER! Risk of injury
through burning!
The metal surfaces become very hot
during operation. Only touch the
handles and control elements of the
device during operation.
6.1 Heating up
1. Open the lid4 of the contact grill up-
wards. Be careful not to raise the lid
any further after it is vertical.
2. Grease the grill plates13 with vegeta-
ble oil or butter if appropriate.
3. Place a grease drip tray16 under the
oil/fat runoff of the bottom grill plate8.
4. Close the lid4 downwards in order to
close the contact grill.
5. Before plugging in the device, check
that both thermostat controls9 +15
are set to the marking "•".
6. Insert the mains plug6 into a wall sock-
et corresponding to the specifications of
the rating plate.
__RP100156_B4.book Seite 6 Dienstag, 10. Juni 2014 7:08 19

Silvercrest SKG 1700 A2 Specifications

General

Brand	Silvercrest
Model	SKG 1700 A2
Category	Grill
Language	English