- 5 -
Setup
Place the kitchen scales on a level and slip-free
surface.
Notice
This appliance is equipped with non-slip rubber
feet. As furniture surfaces may be made of a variety
of materials and are treated with many diff erent
types of cleaning agents, it cannot be completely
ruled out that some substances contain ingredients
which may perish the rubber feet and soften them. If
possible place an anti-slip material under the feet of
the appliance.
Operation
Setting the units of measurement
You can choose between the metric and the Anglo-
American (Imperial) system. From 0 g - 999 g the
unit is indicated in g/oz and from 999 g in kg/lb
and g/oz.
Additionally, you can weigh liquids.
In the metric system:
• Milliliter (ml) water
• Milliliter (ml) milk.
In the Anglo-American system:
• Fluid ounces (fl ´oz) water
• Fluid ounces (fl ´oz) milk.
Press the button ON/OFF 1) 5. The scale is
now in the weighing mode. The programmed
unit adjustment appears under or to the right
of the weight indication in the display 6.
To switch between the metric and Anglo-2)
American systems, press the button UNIT 8
until the measurement unit details change.
To alternate within measurement unit systems 3)
between...
g/kg - ml water - ml milk
or
oz/lb:oz - fl ´oz water - fl ´oz milk
... briefl y press the button UNIT 8 until the desired
measurement unit appears in the display 6.
Notice
Always fi ll liquids into a container before you
measure it!
Weighing
Press the button ON/OFF 1) 5 to the switch the
scales on (weighing mode). The display 6
will light up.
Programme in the desired measurement unit 2)
(see chapter "Setting the units of measurement").
The scales indicate a weight of "0". "O" is shown in
the display 6 and on the left.
Place a suitable receptacle on the scales and 3)
press the button Z/T 4. The scales once
again shows "0", it does not take account of
the weight of the receptacle.
Place the item(s) to be weighed into the receptacle.
Notice
If a button is not pressed or there is not a change
of the current measured weight after approx.30
seconds, the display lighting 6 switches itself off .
After a further 90 seconds the appliance returns to
the Clock Mode.
Adding & Weighing
(Tare Function)
You can repeatedly set the scale back to "0" in
order to weigh additional partial quantities.
For this, press the button Z/T 1) 4 once. In the
display 6 "TARE" appears on the left. The
scales indicate a weight of "0" again.
Place the additional item(s) to be weighed 2)
into the receptacle.
In the display 6 the weight of the newly added
item(s) is shown.
IB_64679_SKW3EDSA1_LB3.indb Abs1:5IB_64679_SKW3EDSA1_LB3.indb Abs1:5 16.05.2011 8:48:12 Uhr16.05.2011 8:48:12 Uhr
To Next Page
Loading...
Need help?
General
