Silvercrest SPUH 90 A1 User Manual

Operation
Radio operation
1. Press the button
o
to switch the device on.
2. Using the sound level controller VOLUME
h
, select the desired sound level.
3. Place the waveband selector switch
f
at the desired frequency range
(FM/AM).
4. Adjust the TUNING regulator
d
to select the desired radio station.
The frequencies can be read off from the frequency scale
s
.
5. Press the button
o
to switch the device off.
Setting up the telescope aerial
• Remove the telescope aerial
a
from its retainer and set it up.
• Extend the telescope aerial
a
completely.
To improve reception in the FM frequency range, slowly turn the end of the
telescope aerial
a
in various directions. As soon as you have found a position
with good reception from your desired radio station, leave the telescope
aerial
a
in this position. For the reception of AM transmissions, an antenna
is built into the device. For improved reception, alter the position of the device
in radio mode.
Setting the time
1. Press the button TIME
i
for 2 seconds. The time indicator in the display
j
blinks.
2. Press or hold the button HOUR
r
to set the hours.
3. Press or hold the button MIN
t
to set the minutes.
4. Press the button TIME
i
once again. The programmed time will be
taken over.
- 10 -

Silvercrest SPUH 90 A1 Specifications

General

Brand	Silvercrest
Model	SPUH 90 A1
Category	Alarm Clock
Language	English