SilverCrest SSSH 600 A1
English - 13
It is recommended to clean the immersion blender (5) or whisk (6) directly after use in order
to prevent the processed foods from drying. In particular, after processing very salty foods the
immersion blender (5) or whisk (6) should be immediately rinsed with clean water.
Remove the plug from the socket.
Remove the immersion blender (5) or whisk (6) from the motor block (4).
Disconnect the whisk (6) from the adapter by removing the shaft of the whisk (6) from the adapter
holder.
Clean the motor block (4) and the adapter with a soft damp cloth and then dry it well. Cleaning in the
rinsing bath would result in irreparable damage!
You can clean the immersion blender (5), whisk (6) and measuring cup in a basin. After cleaning, rinse
with plenty of clean water to remove any detergent residue. Then thoroughly dry the immersion blender
(5), whisk (6) and measuring cup.
9. Storing the device when not in use
If the hand-held blender is not going to be used for a long period of time, clean it as described in the
previous section. Store this in a clean, dry location out of reach of children.
10. Troubleshooting
If your hand-held blender does not work as usual, use the following instructions to try and solve the
problem. If working through the following tips does not eliminate the fault, please contact our hotline (see
the ‘Warranty information’ section).
The hand-held blender is not working
The plug is not inserted. Insert the plug into the power socket.
The power socket is faulty. Try the appliance in another power socket which definitely works.
The blade does not rotate / rotates with difficulty
The motor block (4) and immersion blender (5) or whisk (6) are not correctly assembled. Disconnect the
device from the mains and check the assembly.
Is there an object in the mixing container? If so, remove this.
The mixed foods are too hard or too tough.
To Next Page
Loading...
Need help?
General
