Silvercrest WIRELESS SOCKET SET User Manual

11 GB
Setting-up operation

Using the remote-
control (fig. A)
The remote control will control up to 4
remote-controlled sockets (individually,
in groups or simultaneously).
1. Press the desired ON button of the
channel ON/ OFF button
2
(A, B,
C or D) on the remote control of
the device you wish to switch on.
The LED operating status display
5
will light.
2. Press the desired OFF button of the
channel ON / OFF button
2
(A,
B, C or D) on the remote control for
the device you wish to switch off.
The LED operating status display
5
will go out.
3. Confirm the ALL ON / OFF button
3
to switch all remote-controlled
sockets simultaneously.

Trouble-shooting
If the remote control does not
work, please check the follow-
ing points:
Prob-
lem
The operating indica-
tor
1
on the remote
control device illumi-
nates but there is no
reaction
Rem-
edy
· Check if the battery still
has sufficient Ampere. If
necessary, install a new
battery.
Prob-
lem
No indicator light
1
on remote control
when pressing “ON”
or “OFF”
Rem-
edy
· Check if the battery is
inserted correctly.
· Check if the battery has
good contact, if necessary
press down
Prob-
lem
No reaction from
consumer
Rem-
edy
· Assign a new code to the
wireless socket (see “Set-
ting up the wireless socket”).
· Check - by walking closer to
it - that the range is correct
for the desired location.
Prob-
lem
Range is too small
Rem-
edy
· For large ranges, ensure
that as few walls and as
little furniture as possible
are in the way of the
remote control and the
radio-controlled socket.
· If the range is too small
at times, the reason could
be a remote control which
works on a similar fre-
quency. Whenever this re-
mote control is active, the
range declines (e.g. wire-
less headphones, radio-
controlled movement
alarms, radio gongs
etc.).

Silvercrest WIRELESS SOCKET SET Specifications

General

Brand	Silvercrest
Model	WIRELESS SOCKET SET
Category	Accessories
Language	English