15
en
WARNING
If the unit does not pass a safety test, do
not operate it. See your authorized dealer.
Safety Interlock System Tests
This unit is equipped with a Safety Interlock System. Do
not attempt to bypass or tamper with the switches and
devices.
Test 1 — Engine should NOT crank if:
OFF), OR
Test 2 — Engine SHOULD crank if:
AND
Test 3 — Engine should SHUT OFF if:
-
pressed (parking brake OFF).
Test 4 — Check Mower Blade Stopping Time
Mower blades and mower drive belt should come to a
Test 5 — Check Reverse Mow Option (RMO)
if the PTO has been switched on and RMO has not
been activated.
-
tivated.
Oil Recommendations
We recommend the use of Briggs & Stratton Warranty
-
SH, SJ or higher. Do not use special additives.
Outdoor temperatures determine the proper oil viscosity for
the engine. Use the chart to select the best viscosity for the
outdoor temperature range expected.
Checking/Adding Oil
Before adding or checking the oil
1. Remove the dipstick (A, Figure 3) and wipe with a
clean cloth.
2. Insert and tighten the dipstick.
3. Remove the dipstick and check the oil level. It should
be at the FULL mark (B) on the dipstick.
C). Do not
After adding oil, wait one minute and then
recheck the oil level.
5. Replace and tighten the dipstick.
* Below 40°F (4°C) the use of SAE 30 will result in hard starting.
** Above 80°F (27°C) the use of 10W-30 may cause increased oil consumption. Check oil
level more frequently.
Operation
To Next Page
Loading...
Need help?
General
