Simplicity Scout Plus User Manual

15
MAINTENANCE
(Fig 20)
(Fig 21)
(Fig 22)
Exhaust HEPA Type
Filter Replacement
IMPORTANT! Ensure that the cleaner
is disconnected from the power supply
before performing any maintenance
procedures.
The Exhaust HEPA Type filter is installed
behind the air outlet grill. This filter is
washable. When dust or dirt is visible
on the surface of the filter, the filter
should be replaced or washed with warm
water to maintain optimal performance.
It is recommended to replace the filter
every 6 months or when it becomes
visibly dirty. This may vary depending on
frequency of use. Please ensure all filters
have been correctly installed into the
machine before use.
• Press the Exhaust Filter Release Button
to access the Exhaust HEPA type filter.
(Fig 20)
• Remove the filter by pulling on the filter
tabs as shown. (Fig 21)
Cleaning the Motorized
Powerhead
IMPORTANT! Ensure that the cleaner
is disconnected from the power supply
and the powerhead is disconnected
from the wand before performing any
maintenance procedures.
The agitator brush must be free of debris
for effective cleaning and for maximum
suction. (Fig 22)
• Disconnect the motorized powerhead
from the vacuum wand and turn it over
to inspect the agitator brush.
• If a build-up of debris is wound around
the agitator brush, remove by carefully
cutting hair or debris with scissors.
Avoid damaging or cutting the bristles.
The powerhead has an overload

Simplicity Scout Plus Specifications

General

Brand	Simplicity
Model	Scout Plus
Category	Vacuum Cleaner
Language	English