TROUBLE SHOOTING
Below is a chart detailing the most common problems, their causes and solutions. Before shipping any appliance to a service
center please check to make sure that the solution is not listed here:
PROBLEM CAUSE SOLUTION
Steam Press cannot be opened
using Pressing Handle.
Locking Knob is in Locked position. Turn the Locking Knob to the unlocked
position.
Steam Press becomes warm but
DOES NOT remove wrinkles.
Temperature Setting is not high enough
for the fabric attempted.
Gradually increase the temperature until
obtaining the desired results.
Temperature has not been selected. Make a proper selection.
Press is not plugged into an outlet. Plug the appliance in.
Press DOES NOT get warm.
Automatic Shut-Off has engaged.
The Pressing Plate has been raised for
more than 15 minutes without use.
Press the *POWER* button again.
To Next Page
Loading...
Need help?
General