To Next Page

To Previous Page

1 2

Install the darning plate. (1) Change the all purpose foot to

the button sewing foot. (2) Set the stitch length to "0".

To sew a few securing stitches, set the machine for straight

stitch, with the stitch width set at "0".

Raise the needle out of the fabric. Set the machine for zig-

zag stitch, then set the width to number "3" - "5". Turn the

handwheel to check that the needle goes cleanly into the left

and right holes of the button. Adjust the stitch width, as

needed, according to the distance between the holes of the

button. Slowly sew on the button with about 10 stitches.

Raise the needle out of the fabric. Set the machine for

straight stitch again, with the width at "0" sew a few securing

stitches to finish.

If a shank is required, place a darning needle on top of the

button and sew. For buttons with 4 holes, sew through the

front two holes first, push the work forward and then sew

through the back two holes.

Sewing on Buttons

Singer 2277 User Manual

Other manuals for Singer 2277