12
ENGLISH
6. Use the Humidity button to change set humidity in Auto Mode.
7. Use the Timer button to set Unit turn-off time. (Or Turn-on time if the unit is off).
8. Use the Mode button to select Drying mode if the unit will not be used for a long time.
9. Once the desired setting is chosen, you may use the Lock Button to lock the keypad.
Note: The unit will not work if the water tank is full. Read the following Drainage Section for
information on how to empty the tank.
DRAINAGE
The unit has a 5,3L water tank attached that must be emptied when it is full. When the water tank
is full, the unit stops automatically. The water tank icon fl ashes and a beep sound is produced
(15 times) as an alarm.
• Put one hand on the concave part on the
bottom of water tank to carefully remove the
water tank from the unit. Then remove the
water tank cover and empty the water.
• Replace the water tank cover and insert the
water tank into the unit gently until it reaches
the correct position. Then, you can restart the
unit.
Warning: Empty the water only when the water tank is full. Make sure that the assembly of the
water tank cover and the water tank are correct.
CONTINUOUS DRAINAGE
You can also connect a drainage pipe (inner diameter 12 mm) for continuous drainage to avoid
emptying the tank.
Note: A 2m drainage pipe is provided with the unit.
To Next Page
Loading...
Need help?
General
