7 9
10
11
8
6
5
1
2
3
4
Introduction – 1
English
INTRODUCTION
Optimal use and maintenance are described in these instructions. This product is not intended for industrial or commercial use.
Additional assistance, by region, may be found online at www.singer.com.
1. Feed Teeth Lever — Move from side to side to engage or
disengage the feed teeth. Positioned at the back of the free
arm.
2. Accessory Tray / Free Arm — Provides a at surface
when sewing and allows storage for your accessories.
Remove the accessory tray to use the free arm which makes
it easier to sew, e.g., trouser hems and sleeves.
3. Thread Knife — For trimming thread ends at the end of
sewing.
4. Threading Slots — Thread paths with tension discs and
take up lever.
5. Reverse Button — Press and hold to sew in reverse or to
make a tie-o, e.g., when securing the beginning or ending
of a seam.
6. Start/Stop Button — Press to start and stop sewing with-
out using the foot control.
7. Thread Tension Dial — Adjustable for setting the desired
tension for your stitch, thread and fabric.
8. Machine Operation Controls — Functions used to make
your sewing more convenient.
9. Display — Current stitch and settings are displayed.
10. Hand Wheel — Used to manually control the movement of
the needle and the thread take-up lever.
11. Function Buttons — Control the stitch width and the stitch
length, as well as the pattern memory for Alphanumeric
stitches.
12. Stitch Chart — View all stitches available on your ma-
chine.
Intended Use
Machine Overview
To Next Page
Loading...
Need help?
General
