8
ENGLISH
the wall socket. But the soleplate is still hot, never touch it.
7. After cooling down, you can place the iron onto the thermal insulating
cushion.
CAUTION: During the operation or after fi nish ironing, never place the
hot soleplate on any area except the thermal insulating cushion.
CLEANING AND MAINTENANCE
Before cleaning, fi rstly disconnect the power outlet and let the appliance cool
down.
1. Empty the boiler above a sink and rinse it a few times with clear water.
Wipe fl akes and any other deposits on the soleplate with a damp cloth or a
nonabrasive (liquid) cleaner.
NOTE: Do not use chemical, steel, wooden or abrasive cleaners to scrape
the soleplate.
2. Clean the upper part of iron with a soft damp cloth. Wipe the water drop on
the steam generator and the thermal insulating cushion with dry cloth.
3. When do not use the appliance for a long time, pour out the water in the
tank, and store the iron on the thermal insulating cushion.
4. Wind the iron cord and power cord around the cord winding groove.
Removal of mineral deposits
CAUTION: To avoid a risk of scald, make sure the steam generator has
been cooled down completely before unscrewing the drain water cap.
1. Remove the detachable water tank.
2. Hold the steam generator with your two hands and shake it gently.
3. Pull out the self-cleaning cover and unscrew the screw with a coin (Fig. 1).
4. Empty the contents by removing the water in the sink. Fill the steam
generator with clean water via the self-cleaning cover. Close the cover and
move softly (Fig. 2 & 3).
5. Empty the steam generator water again. Repeat the process until the water
comes out clean (Fig. 4).
6. After completing the cleaning procedure, tighten the screw fi rmly and close
with the self-cleaning cover (Fig. 5).
To Next Page
Loading...
Need help?
General