SKY-WATCHER EQ1 User Manual

7
INSERTING EYEPIECE (Fig.14)
1) Loosen the thumbscrews on the end of the
focus tube.
2) Insert the diagonal into the focus tube
and re-tighten the thumbscrews to hold
the diagonal in place.
3) Loosen the thumbscrews on the diagonal.
4) Insert the desired eyepiece into diagonal
and secure by re-tightening thumbscrews.
INSERTING EYEPIECE (Fig.13)
1) Unscrew the thumbscrews
on the end of the focus
tube to remove the
black plastic end-cap.
2) Insert the desired
eyepiece then
re-tighten thumb
screws to hold the
eyepiece in place.
(reflector)
(refractor and Maksutov)
EYEPIECE ASSEMBLY
ATTACHING THE FINDERSCOPE (Fig.10, 11)
1) Locate the finderscope optical assembly.
2) Remove the two knurled thumbscrews near
the end of the telescope main body. (near the
front of the telescope main body for the reflector)
3) Position the finderscope bracket over the
screws in the telescope main body.
4) Secure the finderscope bracket with the
two knurled thumbscrews.
FINDERSCOPE ASSEMBLY
Fig.10 Fig.11
Fig.13
Fig.14
Fig.12
RED DOT FINDER ASSEMBLY
ATTACHING THE RED DOT FINDER
(Fig.12)
Slide the red dot finder bracket into the
rectangular slot and tighten the screw to
hold the red dot finder in place.

SKY-WATCHER EQ1 Specifications

General

Brand	SKY-WATCHER
Model	EQ1
Category	Accessories
Language	English