2
Soap Dispenser Installation
NOTE: ESD-2100 Shown, instructions applicable for all Sloan soap dispensers
Installing the Touchfree Counter Mounted System
Prior to beginning installation, study the exploded view of the Touchfree Counter-Mounted System and locate all the
pieces. Also, look beneath the countertop to and a suitable place for mounting of the Battery Box so that it will not
interfere with system components or plumbing.
Feed the cable and the shank of
the Dispenser Assembly through
the hole in the countertop. Point
the spout of the Dispenser into the
sink bowl.
From underneath counter, feed
retaining washer and nut over
spout cable onto threaded shank
of spout. Tighten the nut securely.
Align the indent inside the top of
the Motor Assembly/Bottle
Support with the indent on the
shank of the Dispenser Assembly
and firmly push the Motor
Assembly/Bottle Support up, onto
the shank.
NOTE: Hold the Cable firmly
out of the way as you push up on
the Motor Assembly/Bottle
Support. Continue pushing
upward until the vertical slots in
the Dispenser shank and the
Motor Assembly/Bottle Support
line up.
Secure the Motor Assembly/Bottle
Support to the Dispenser
shank by pushing the
Retaining Clip into place
through the vertical slots, until it
goes all the way through the Motor
Assembly.
NOTE: Motor Assembly Bottle
Support will rotate 360° to avoid
any obstruction.
Remove the cover from the
Battery Box by loosening the
two captive screws on the Battery
Box cover. Position the Box on a
convenient (vertical or horizontal)
surface under the counter top that
will allow access for battery
changing. Attach the Box to the
surface using the two screws
and anchors (if attaching to a
plaster or masonry surface).
Use the Wall Clip to secure the
Power Cable to a wall or other
under-counter surface if desired.
Place four alkaline “D” Cell
batteries into the Battery Box
cover. The batteries must be
positioned according to the
diagrams shown on the inside of
the cover.
NOTE: If the batteries are not
properly installed or the cover is
not properly positioned on the
Box, the System will not work.
Position the cover (with batteries
installed) on the Battery Box and
tighten the two captive screws.
IMPORTANT: Connect the two
halves of the Cable and by visually
lining up the white stripes on each
half and gently pushing the cable
connectors together until the stripes
touch.
Improperly assembled
connectors can cause unit to
not function as intended.
After the batteries are installed in
the battery box, connect the two
halves of the power cable and
allow 20 seconds before the
system is ready to dispense soap.
To Next Page
Loading...
Need help?
General
