Sloan ESD Series User Manual

3
Soap Rell Bottle Installation and Removal
Rell Installation
(rell separately)
Feed the dispense tube on the
Refill Bottle up through the
Motor Assembly/Bottle Support
and Dispenser Assembly,
aligning the two indents in the
Bottle and the Support. Slide the
Bottle upward until it snaps into
place.
NOTE: The refill is not properly
installed until you hear the “snap”
(as the Green release latch on the
Motor Assembly/Bottle Support
engages).
Test the
System by
placing your
hand under
the spout of
the Dispenser
Assembly (in front of the sensor
window) at least three or four
times, until foam soap appears.
If the System does not dispense
soap after placing your hand in
front of the sensor several times,
repeat several more times. If no
sound heard from motor assembly
after placing hands in front of sen-
sor, check to see that the Cable
halves are firmly connected, that
the batteries are “good”, and that
the Battery Box cover is properly
positioned and fastened to the
Box. Check for bent contact pins
inside connector. If unit is
multi-activating, check for bent
contact pins inside connector.
Rell Removal
Grasp the empty Refill Bottle
with one hand and use the other
hand to push the Green release
latch on the Motor Assembly/
Bottle Support to the right
(counterclockwise as seen from
above).
Grasp the empty Refill Bottle with
one hand and use the other
hand to push the Green release
latch on the Motor Assembly/
Bottle Support to the right (coun-
terclockwise as seen from above).
Cleaning the Counter Mounted System
Use only mild soap and water to clean the Touchfree Counter Mounted
System spout. Cover the sensor window with your thumb while cleaning the
spout so that you do not continue to dispense soap.
DO NOT use abrasives to clean the TouchFree Counter-Mounted System
(as this may damage the finish or the sensor window).

Sloan ESD Series Specifications

General

Brand	Sloan
Model	ESD Series
Category	Plumbing Product
Language	English