Item Part Description
No. No.
- EBF-1004-A Solenoid Filter Replacement Kit; includes Filter Screen
Assembly and O-ring
OPTIONAL TRIM PLATES
10 ETF-312-A 4” (102 mm) Centerset Trim Plate Kit for EBF-187 Faucet
(Faucet Only); includes Back-up Spacer, Self-tapping
Screw and CP Single Hole Trim Plate Assembly
11 MIX-101-A 4” (102 mm) Centerset Trim Plate Kit for EBF-85 or EBF-
187 Faucet with Optional Mixing Valve; includes Back-up
Spacer, Self-tapping Screw and CP Dual Hole Trim Plate
Assembly
12 ETF-510-A 8” (203 mm) Centerset Trim Plate Kit for EBF-85 or EBF-
187 Faucet (Faucet Only); includes two (2) Finger Nuts,
two (2) Washer Gaskets, two (2) Fender Washers, Base
Gasket, Back-up Spacer and CP Single Hole Trim Plate
Assembly
13 MIX-104-A 8” (203 mm) Centerset Trim Plate Kit for EBF-85 or EBF-
187 Faucet with Optional Mixing Valve; includes one (1)
Finger Nut, one (1) Washer Gasket, one (1) Fender Washer,
Base Gasket, Back-up Spacer and CP Dual Hole Trim Plate
Assembly
OPTIONAL MIXING VALVES
14 MIX-60-A Below Deck Mechanical Water Mixing Valve (BDM
Variation)
15 MIX-135-A Below Deck Thermostatic Water Mixing Valve (BDT
Variation)
16 MIX-110-AA Optimix
®
Deck Mounted Water Mixing Valve
For additional information about Sloan Mixing Valves or Trim Plates, consult our
Installation Instructions and Maintenance Guides.
SLOAN VALVE COMPANY • 10500 Seymour Avenue • Franklin Park, IL 60131
Phone: 1-800-982-5839 or 1-847-671-4300 • Fax: 1-800-447-8329 or 1-847-671-4380
www.sloanvalve.com
Printed 11-08
Copyright © 2008 SLOAN VALVE COMPANY
Item Part Description
No. No.
1 EBF-10-A Faucet and Sensor Assembly
(EBF-85 with Black Plastic Throat Plate)
EBF-170-A Faucet and Sensor Assembly
(EBF-187 with CP Metal Throat Plate)
EBF-1009-A Fiber Optic Sensor Cable Assembly Only
(replaces EBF-12-A, includes lens holder)
2 ETF-1021-A 0.5 gpm (1.9 Lpm) Spray Head with Key (female thread)
ETF-1022-A 2.2 gpm (8.3 Lpm) Aerator Spray Head with Key (female
thread)
ETF-1027-A 2.2 gpm (8.3 Lpm) Laminar Flow Spray Head (female thread)
ETF-435 Replacement Key ONLY for ETF-1021-A and ETF-1022-A
Spray Heads. (NOT required for ETF-237 Laminar Flow Spray
Head)
3 ETF-295-A 4” (102 mm) Centerset Trim Plate Kit for EBF-85 Faucet
(Faucet Only); includes two (2) Nuts, two (2) Hex Screws, two
(2) Flat Plate Washers, Single Hole CP Cover Plate and Black
Plastic Base Plate
ETF-299-A 4” (102 mm) Centerset Trim Plate Kit for EBF-85 Faucet with
Optional Mixing Valve includes Dual Hole CP Cover Plate and
Black Plastic Base Plate (not shown)
4 ETF-290-A Faucet Mounting Kit, includes Rubber Gasket, Flange Nut and
ETF-297 1/4” to 3/8” Reducing Compression Fitting
Connector
5 ETF-297 1/4” to 3/8” Reducing Compression Fitting Connector
6 ETF-617-A 3/8” Bak-Chek
®
Tee Compression Fitting
7 EBF-11-A Solenoid Valve Module Assembly; includes Solenoid
Enclosure, Solenoid Body, and Filter Cap
EBF-4 Four (4) C-size Alkaline Batteries
8 EBF-16 ETF-208, 3/8” (10 mm) Ferrule, two (2) supplied and ETF-
209, 3/8” (10 mm) Compression Nut, two (2) supplied
9 EBF-25-A Mounting Bracket Kit; includes Wall Bracket Base, Wall
Bracket, Self-tapping Screw, two (2) Wood Screws plus
Washers and Plastic Anchors, two (2) Screws plus Washers
and Toggle Nuts, two (2) Screws plus Washers and Hollow
Wall Anchors
NOTICE: The information contained in this document is subject to change without
notice.
1
2
9
7
3
10
11
12
13
5
6
14
16
15
8
8
4
PARTS LIST
If further assistance is required, please contact the Sloan Valve Company Installation Engineering Department at 1-888-SLOAN-14 (1-888-756-2614)
To Previous Page
Loading...
Need help?
General
