Smartgen BAC06A User Manual

BAC06A Switch-type Battery Charger User Manual
BAC06A Switch-type Battery Charger Version 1.5 2020-03-13 Page 5 of 7
4 SPECIFICATION
Table 2 Product Parameters
Category
Items
12V
24V
Input
Characteristi
cs
Nominal AC Voltage
AC (95～280)V
Max. AC Voltage
AC (90～305)V
AC Frequency
50Hz/60Hz
Max. Input Current
2A
Max. Efficiency
85%
Output
Characteristi
cs
Charging Current
4A～6A,(Error±2%)
2A～3A,(Error±2%)
Factory Charging
Current
6A
3A
Max. Power
85W
Min. Voltage
7.5V
No-load Voltage
13.8V, (Error ±1%)
27.6V, (Error ±1%)
No-load power
consumption
<3W
Insulation
Insulation Resistance
Between input and output, input and shell both are:
DC500V 1min R
L
≥500MΩ
Insulation Voltage
Between input and output, input and shell both are:
AC1500V 50Hz 1min
Leakage current: I
L
≤3.5mA。
Working
Conditions
Working Temperature
(-30～+55)°C
Storage Temperature
(-40～+85)°C
Working Humidity
20%RH～93%RH (No condensation)
Profile
Weight
0.65kg
Dimension
143mm×96mm×55mm (Length*Width*Height)
5 SETTING
5.1 VOLTAGE ADJUSTMENT
When adjusting the voltage on the spot, disconnect the battery from the charger, and then measure
the output voltage of the charger while adjusting voltage potentiometer (VOLT) to a proper value.
5.2 CURRENT ADJUSTMENT
Connect battery output firstly. When charging voltage is not higher than 25.0V (12.5V) measure
charging current; adjust the current potentiometer (AMP) and set proper charge current. Output
current can also be estimated according to the current potentiometer scales.

Smartgen BAC06A Specifications

General

Brand	Smartgen
Model	BAC06A
Category	Battery Charger
Language	English