SMC Networks ZL112A Series User Manual

Document No.ZL-OM01001
- 20 -
■Replacement Procedure for Filter element (ZL112A-FE1-A)
■Replacement procedure for Sound absorbing material (ZL112A-SE1-A)
Replacement Procedure
The suction cover can be attached or detached at
a touch.
Suction cover can be removed by pushing the
suction cover levers (2 pcs.) on the side. (It can be
removed from the opposite side as well.)
Replace the filter element assembled in the filter
case.
Check that the gasket is correctly fit in the groove
before mounting the suction cover.
Check that the lever hook is locked in the correct
position when mounting the suction cover. If the
hook or the lever is damaged or deformed, replace
the suction cover assembly.
The sound absorbing material can be replaced with a single operation.
Push the area where word “PUSH” is printed on the silencer cover in direction shown in Fig. 1.
The silencer cover will come out. (See Fig. 2) Remove the sound absorbing material 1 and 2 and
replace with the new ones. (See Fig. 3)
After replacing the sound absorbing material, place the end surface of the sound absorbing
material 1 to the end surface of the diffuser while engaging the hooks to the hook holes and
push the silencer cover back into the place. (See Fig. 4)
* When the product is mounted
with the silencer cover side facing
to the wall, maintenance shown in
the figures above is not possible.
Remove the product from the wall
for maintenance.

SMC Networks ZL112A Series Specifications

General

Brand	SMC Networks
Model	ZL112A Series
Category	Industrial Equipment
Language	English