Specifications
Rated pressure range
Regulating pressure range
Proof pressure
Min. regulating unit
Fluid
Power supply voltage
Current consumption
Switch output
Repeatability
Analog
output
Hysteresis
Display
Display accuracy
Indicator light
Temperature characteristics
Standard
Note 1)
Max. load current
Max. applied voltage
Residual voltage
Response time
Short circuit protection
Voltage output
Note 2)
Current output
Note 3)
Hysteresis mode
Window comparator mode
ZSE30 (Vacuum/Low pressure)
–100.0 to 100.0 kPa
–101.0 to 101.0 kPa
500 kPa
0.2 kPa
±0.2% F.S. ±2 digit or less
±2% F.S. ±2 digit
(at 25°C ambient temperature)
ISE30 (Positive pressure)
0.000 to 1.000 MPa
–0.100 to 1.000 MPa
1.5 MPa
0.001 MPa
±0.2% F.S. ±1 digit or less
±2% F.S. ±1 digit
(at 25°C ambient temperature)
Air, Inert gas, Non-flammable gas
12 to 24 VDC, Ripple (p-p) 10% or less (With power supply polarity protection)
45 mA or less (at no load)
NPN or PNP open collector output: 1 output
80 mA
30 V (With NPN output)
1 V or less (With load current of 80 mA)
2.5 ms or less (Response time selections with anti-chattering function: 20, 160, 640, 1280 ms)
Ye s
Output voltage: 1 to 5 V ±2.5% F.S. or less (With rated pressure range)
Linearity: ±1% F.S. or less, Output impedance: Approx. 1 kΩ
Output current: 4 to 20 mA ±2.5% F.S. or less (With rated pressure range)
Linearity: ±1% F.S. or less
Maximum load impedance: 300 Ω with power supply voltage of 12 V;
600 Ω with power supply voltage of 24 V
Minimum load impedance: 50 Ω
Adjustable (can be set from 0)
3 1/2 digit, 7-segment indicator, 2-color display (Red and green)
Sampling cycle: 5 times/s
Light up when output is ON (Green)
±2% F.S. or less (based on 25°C)
IP40
Operating: 0 to 50°C, Stored: –10 to 60°C (No freezing or condensation)
Operating and stored: 35 to 85% RH (No condensation)
1000 VAC for 1 min. between live parts and enclosure
50 MΩ or more between live parts and enclosure (at 500 VDC)
10 to 150 Hz, 1.5 mm or 20 m/s
2
amplitude in X, Y, Z directions for 2 hours each
100 m/s
2
in X, Y, Z directions 3 times each
Compliant with CE Marking and UL (CSA) standards
Piping Specifications
Part
Port
size
Wetted part material
Weight
One-touch fitting
Straight type
One-touch fitting
Elbow type
With lead wire
with connector (2 m)
Without lead wire
with connector
01
R 1/8
M5 x 0.8
—
—
81 g
43 g
T1
NPT 1/8
M5 x 0.8
—
—
C4H
—
ø4 mm
ø5/32 inch
—
C6H
—
ø6 mm
—
O-ring: NBR
76 g
38 g
N7H
—
ø1/4 inch
—
Sensor pressure receiving area: Silicon, Piping port: C3602 (Electroless nickel plated), O-ring: HNBR
C4L
—
—
ø4 mm
ø5/32 inch
C6L
—
—
ø6 mm
O-ring: NBR, fitting: PBT
78 g
40 g
N7L
—
—
ø1/4 inch
Note 1) When switch output is selected, analog output is not available.
Note 2) When voltage output is selected, a simultaneous selection of switch output and current output is
not available.
Note 3) When current output is selected, a simultaneous selection of switch output and voltage output is
not available.
Enclosure
Operating temperature range
Operating humidity range
Withstand voltage
Insulation resistance
Vibration resistance
Impact resistance
Environmental
resistance
To Next Page
Loading...
Need help?
General
