EN - 6
USE (Fig. E-F-G)
• Lift the tank cover (4) and pour fresh water
in the tank (5) being sure not to exceed the
indicated ‘Max’ level. Replace the water
tank cover when full (9).
• Lift the coffee bean container lid (2) and
introduce the coffee beans into the container
(3).
• Check that the drip tray (19) is correctly
positioned. Make sure that the tray which
can be washed in the dishwasher (20) is
correctly inserted inside it and mount the
mug holder (21).
• Press the button (9), the machine starts the
heating phase and the keys light up ashing
in sequence.
At the end of the heating, a self-cleaning
cycle of the internal circuits is carried out
and, once the cycle is nished, the machine
is ready to be used.
• It is possible to adjust the position of the
dispenser (11) according to the cup used.
For very high cups it is possible to remove
the drip tray (19).
At the rst use it is recommended to
make at least one coffee to make a
complete break-in of all the circuits.
It is also recommended to run a
thorough milk circuit cleaning cycle
or to manually clean the milk system
(13) components. Please consult
the “Cleaning and maintenance”
section to this end.
We recommend setting the water
hardness upon first use. Please
see the “Water hardness settings”
paragraph for this reason.
Remember to reassemble the tray
(19) at the end of any dispensing.
Use
Turn the knob (6) and match the indicator (42)
with the desired grinding level.
The grinding grain adjustment must
be carried out when the grinder is
in operation or on rst use when
the bean container is completely
empty; turning the knob (6) with
the grinder stopped and the beans
inside could damage the grinding
unit.
BEFORE FIRST USE
(Fig. A-H)
• Unpack the appliance carefully and remove
all packaging materials.
• Rinse the dismountable components such as:
water tank (5), lids (2,4), door (8), grounds
container (17), drip tray (18), drip trays
(19,20), mug holder (21), infuser group
(22), the milk system (13), the milk bottle
with lid (23) and the milk tube (24).
Before use, check that all
components are intact and do not
show any cracks or breakage.
To clean the milk system (13),
remove the system from the
dispenser and take of the various
components as shown in fig.
H, rinse under running water,
dry thoroughly and re-mount the
machine.
ASSEMBLY OF COMPONENTS
(Fig. E)
• Place the machine on a at surface and x
the drip tray
(19).
• Connect the power supply cable to the
socket on the rear of the machine and the
other end to a power socket
.
To Next Page
Loading...
Need help?
General
