Snapper 10 Series User Manual

ONCE A YEAR
STAND MOWER ON REAR BUMPER
• BLADE SPINDLE : Two shots of grease through
grease fitting (2-L) is required. The fitting is between
the deck and the blade.
FIG. 3
I ■ I
• DIFFERENTIAL: Lubrication of the differential should
be done by your SNAPPER dealer. The lubricant used
in the differential is a clinging grease which does not
flow. Therefore, making an accurate inspection of the
lubricant level is difficult.
• CHAIN CASE: Remove CHAIN CASE CHECK
PLUG (3-L) and add about 1 ounce of SNAPPER 0
grease to case if low ■ avoid over filling. Total capaci¬
ty must not exceed 2 ounces. Install new plug.
DIFFERENTIAL
FIG. 4 - DIFFERENTIAL LUBE LEVEL
FIG. 5 - CHAIN CASE
FUEL FILTER- I
(DOES NOT APPLY TO 6HP ENGINES)
: f
i
The in-line filter (between fuel tank and engine) pro¬
tects the engine from damage due to gasoline im¬
purities. Also, check the hose clamps for any
leakage. Replace the filter (S/VAPP£R#1-4359) before
the screen becomes completely clogged with sedi¬
ment. When the filter appears dark (in the screen
area), and/or if the engine becomes "starved''for fuel,
iwill not accelerate properly, misses, or stalls under
load, the filter should be replaced.
IN-LINE
FILTER
FIG. 6 - FUEL TANK & FILTER
OPERATOR’S SEAT
The Operator’s Seat (12-C) may be moved either for¬
ward or toward the rear of unit to enable individuals
of varying heights to comfortably steer and control
the rider.
I I
To adjust the seat, loosen the 2 FORWARD cap screws
(A): they are located on the underside of the slotted
mounting bracket. Move the seat in the desired
direction, and then retighten both screws.
Also, for taller operators, the offset steering wheel
may be rotated 180 degrees. If assistance is needed,-
contact your S/VAPPEP Dealer.
8

Snapper 10 Series Specifications

General

Brand	Snapper
Model	10 Series
Category	Lawn Mower
Language	English