Snapper 10 Series User Manual

LUBRICATION SCHEDULE
EVERY 25 OPERATING HOURS:
• FRONT WHEEL BEARINGS: Lubricate through
grease fittings (6-L) with bearing grease from a
pressure gun.
• REAR LEFT AXLE BEARING: Series 10 riders are
equipped with a grease fitting (8-L). Lubricate the
bearing through the fitting with 2 shots of bearing grease
from a pressure gun.
NOTE: The rear right axle bearing is lubricated by
the transmission on ali models.
FIG. 2-C
REAR AXLE
LUBE POINT
ENGINE SERVICE
• ENGINE: Change oil per instructions in engine
manual. Check oil level before each use.
• AIR CLEANER: Clean and/or replace air cleaner
element(s) per instructions in engine manual.
It is recommended that the air cleaner be periodical¬
ly inspected when adding fuel, and inspected more
frequently when the machine is operated in dry,dusty
environments.
EVERY 6 MONTHS:
• CUTTING HEIGHT LEVER (6-C): Remove the BELT
COVER (2-C) from deck and apply a small amount of
medium grade cup grease to top surface of ad¬
justing cams on both sides, and lubricate idler arm.
LEFT SIDE RIGHT SIDE
AS VIEWED FROM THE UNDERSIDE
OF THE UNIT
6-L
1'L BLADE PEDAL - Pivot Points
2- L BLADE SPINDLE ■ Grease Fittings
3- L CHAIN CASE • Check Plug
5- L DIFFERENTIAL ■ Check Plug
6- L FRONT WHEEL • Grease Fittings
7- L SHIFT ARM - Pivot Points
8- L REAR AXLE - Grease Fitting
9- L YOKE ■ Pivot Points
• BLADE LEVER (3-C): Lubricate idler arm and!
engagement lever at each wear point with a few drops of^
oil. Also lube idler arm pivot at the mower deck.
FIG. 2 - LUBRICATION & SERVICE POINTS
• BLADE PEDALS|(1-L): Lubricate all pivoting and
sliding surfaces where motion occurs (when pedals
are moved) with a few drops of oil. Reinstall BELT
COVER.
FIG. 2-B

Snapper 10 Series Specifications

General

Brand	Snapper
Model	10 Series
Category	Lawn Mower
Language	English