Snapper 10 Series User Manual

STARTING & STOPPING MOWER BLADE |
The Automatic Blade Stop Qontrols should stop the |
blade in less than 3 seconds - AFTER the BLADE I
pedals (4-C) are released. The BLADE lever (3-C) must
be shifted forward and to the right to activate the blade,
and then the BLADE pedals (4-C) are depressed to keep
the blade engaged. j
NOTE: TheBLADEIever will NOT move forward if the
BLADE pedals are depressed first!
Start and Stop blade as follows:
STEP 1; Shift the BLADE lever forward and to the right
to ON and hold in position. Then depress the BLADE
pedals - keep your heel(s) on the pedals to "lock" the
blade into the mowing (rotating) sequence.
NOTE: If STEP 1 is followed, the blade will rotate
whenever the engine is running.
STEP 2: To stop the blade, remove your heel(s)
from the BLADE pedals. The spring loaded BLADE
lever will then snap rearward to OFF.
NOTE: The BLADE lever can be forced into OFF
position while the BLADE pedals are depressed, by
pushing the BLADE lever inward, and then pull rear¬
ward into OFF.
NOTE: If the BLADE lever moves SLOWLY rearward
rather than snapping back, the belt may be too
slack, or the linkage may need lubrication.
Adjust the belt and lubricate the mower (as describ¬
ed in the SERVICE section), and check the blade
stopping time. If the time exceeds 3 seconds, adjust
the blade brake as described on page 9. If the stopp¬
ing time still exceeds 3 seconds, the mower should
not be operated until inspected/repaired by your
dealer.
SERVICE
SERVICE ASSISTANCE/REPLACEMENT PARTS
By returning your mower to an Authorized SNAPPER
Dealer on a yearly basis for inspection and addition
of any new devices to upgrade your mower, the safe¬
ty of the unit’s functions will be assured.
Check the yellow pages under LAWNMOWERS for the
nearest SNAPPER Dealer. Always mention the MODEL
and SERIAL NUMBER of your mower when contacting
the dealer for parts, service, or information.
! 1
For engine parts/service, check under ENGINES
-gasoline,for nearest engine manufacturer’s dealer.
NOTE: Always take the following steps before stan¬
ding your SNAPPER rear engine rider on the REAR
BUMPER.
1. TIGHTEN'FUEL FILLER CAP (10-C)
2. CLOSE (TURN CLOCKWISE) THE VENT VALVE
ON FUEL FILLER CAP (10-C)
3. REMOVE THE BATTERY (1-C) IF THE UNIT IS TO
BE STOOD ON END LONGER THAN 2 HOURS.
It is recommended that rear engine riders sit on the
REAR BUMPER during the servicing of lubrication
points on the underside. When preparing to raise the
front, position BOTH hands near the center of the
front frame "lip" to prevent any possibility of having
fingers pinched by tie rods.
It is recommended that you use Genuine SNAPPER
Replacement Parts to retain the integrity of your
6 mower.

Snapper 10 Series Specifications

General

Brand	Snapper
Model	10 Series
Category	Lawn Mower
Language	English