N In
L Out
S2
L In
S1
N In
L In
N In
4. Power on
5. Add the device
After powering on, the device will enter the quick pairing mode (Touch) during the first
use. The Wi-Fi LED indicator changes in a cycle of two short and one long flash and
release.
The device will exit the quick pairing mode (Touch) if not paired within 3mins. If you
want to enter this mode, please long press the manual button for about 5s until the
Wi-Fi LED indicator changes in a cycle of two short and one long flash and release.
Sou nd Pair ing
Add dev ice in th is mode i f your
devic e s uppor t this fe atur e.
Sca n QR code
GSM dev ices an d devic es with Q R co
de can be a dded in t his mod e.
Quick Pairing
WIF I devic es can be a dded in t his mo
de( make su re the de vice is i n pairi ng
mod e).
Add D evice
Tap “+” and select “Quick Pairing”, then operate following the prompt on the APP.
1
Compatible Pairing Mode
If you fail to enter Quick Pairing Mode (Touch), please try “Compatible Pairing Mode ”
to pair.
Long press Pairing button for 5s until the Wi-Fi LED indicator changes in a cycle of
two short flashes and one long flash and release. Long press Pairing button for 5s
again until the Wi-Fi LED indicator flashes quickly. Then, the device enters
Compatible Pairing Mode.
2
Tap “+” and select “ Compatible Pairing Mode ” on APP.
For Android system:
Enter Wi-Fi password and tap “Next”. Be patient until pairing completes.
For iOS system:
Select Wi-Fi SSID with ITEAD-****** and enter the password 12345678, and then go
back to eWeLink APP and tap “Next”. Be patient until pairing completes.
Shenzhen Sonoff Technologies Co.,Ltd.
English
6
To Next Page
Loading...
Need help?
General
