5
Make sure the neutral wire and live wire connection is correct.
The device still works normally if no physical light switch is connected to S1/S2.
If S1/S2 is connected to a physical light switch, the corresponding working mode is
required in eWeLink APP to select for normal use.
3. Download the eWeLink APP
4. Power on
After powering on, the device will enter the bluetooth pairing mode during the first use.
The Wi-Fi LED indicator changes in a cycle of two short and one long flash and release.
The device will exit the bluetooth pairing mode if not paired within 3 mins. If you want
to enter this mode, please long press the manual button for about 5s until the Wi-Fi LED
indicator changes in a cycle of two short and one long flash and release.
5. Add the device
To Next Page
Loading...
Need help?
General
