Connecting the SDI Signals
31
Connecting the SDI
Signals
Single Link 3G/HD-SDI, Dual Link 3G/HD-SDI, and
Quad Link 3G/HD-SDI signals can be input to the SDI
IN connectors of this unit.
Up to 4-channel Single Link 3G/HD-SDI signals, up to
2-channel Dual Link 3G/HD-SDI signals, or 1-channel
Quad Link 3G/HD-SDI signals can be input. Use the
appropriate input connectors depending on the input
signal, referring to the tables below.
Connecting the Dual Link 3G/HD-SDI signal
or
When only 1-channel Dual Link 3G/HD-SDI signal is
input, the Single Link 3G/HD-SDI signals of up to 2
channels can be input via the SDI IN connectors that are
not used for the Dual Link 3G/HD-SDI signal.
Connecting the Quad Link 3G/HD-SDI signal
To input 2-sample interleave division signals
To input Square division signals
Submenu Setting
[Password Lock] You can protect the setting with a
password so that the settings saved in
the color temperature for [User1] and
the User Preset for [User Preset1]
cannot be changed.
When you protect the values with a
password, set a four-digit number.
The initial password is “0000”. When
you use [Password Lock], change the
initial password first.
[Color Temp./User Pre.]: Select [On]
to protect the setting values
saved in the color temperature
for [User1] and the User Preset
for [User Preset1]. Select [Off]
to not protect with the password.
[Change Password]: Changes the
password.
If you forget the password, refer to Sony
qualified service personnel.
Connector Input signal
SDI IN 3G/HD-SDI Link 1
SDI IN 3G/HD-SDI Link 2
Connector Input signal
SDI IN 3G/HD-SDI Link 1
SDI IN 3G/HD-SDI Link 2
Connector Input signal
SDI IN 3G-SDI Link 1
SDI IN 3G-SDI Link 2
SDI IN 3G-SDI Link 3
SDI IN 3G-SDI Link 4
Connector Input signal
SDI IN Mapping signal of Sub image 1 (upper-
left screen)
SDI IN Mapping signal of Sub image 2 (upper-
right screen)
SDI IN Mapping signal of Sub image 3 (lower-
left screen)
SDI IN Mapping signal of Sub image 4 (lower-
right screen)
To Next Page
Loading...
Need help?
General