96
1
2
3
5
4
Remote Commander
— CCD-TRV107/TRV408 only
The buttons that share the same name on the Remote Commander and your camcorder
function identically to the buttons on your camcorder.
Identifying the parts and controls
To prepare the Remote Commander
Insert 2 size AA (R6) batteries by matching the + and – polarities on the batteries to
the + – marks inside the battery compartment.
1 Transmitter
Point toward the remote sensor to
control the camcorder after turning on
the camcorder.
2 Tape transport buttons (p. 31)
Notes on the Remote Commander
•Point the remote sensor away from strong light sources such as direct sunlight or
overhead lighting. Otherwise, the Remote Commander may not function properly.
•Your camcorder works in the commander mode VTR 2. The commander modes
1, 2 and 3 are used to distinguish your camcorder from other Sony VCRs to avoid
remote control unintentional operations. If you use another Sony VCR in the
commander mode VTR 2, we recommend changing the commander mode or covering
the sensor of the VCR with black paper.
3 DISPLAY button (p. 30)
4 START/STOP button (p. 19)
5 Power zoom button (p. 22)
To Next Page
Loading...
Need help?
General