Sony DR-BT20NX User Manual

16
When you want to connect the unit
to a different BLUETOOTH mobile
phone from the last time, follow the
procedure in “When this unit does
not connect to a BLUETOOTH
mobile phone automatically.”
When this unit does not
connect to a BLUETOOTH
mobile phone automatically
1 Make the BLUETOOTH
connection (HFP or
HSP) from the
BLUETOOTH mobile
phone to this unit.
Refer to the manual supplied
with your BLUETOOTH mobile
phone for operation details.
The list of recognized devices
appears on the display of the
BLUETOOTH mobile phone.
This unit is displayed as
“DR-BT20NX.”
When you use the
BLUETOOTH mobile phone
features both HFP (Hands-free
Profile) and HSP (Headset
Profile)*, set to HFP.
* For details on profiles, see
page 23.
Note
When listening to music by operating this
unit connected to a BLUETOOTH mobile
phone, make the BLUETOOTH
connection by operating the
BLUETOOTH mobile phone. This cannot
be done with the multi function button.
VOL
VOL
MIC
VOL
VOL
Check the following before
operating the unit.
– The BLUETOOTH function is
active on the mobile phone.
– Pairing of this unit and the
BLUETOOTH mobile phone is
complete.
1 Press and hold the
POWER button for about
3 seconds while the unit
is turned off.
The indicator (blue) and indicator
(red) flash together twice, the unit
turns on and then this unit
automatically connects to the last
BLUETOOTH mobile phone that
was used.
Note
Do not press and hold the POWER
button for more than 7 seconds,
otherwise pairing mode is entered.
Tip
This unit will stop trying to connect to
the BLUETOOTH mobile phone after
1 minute. In such a case, press the
multi function button to try to connect
again.
Calling
Jog switch
Multi function
button (MFB)
POWER button

Sony DR-BT20NX Specifications

General

Brand	Sony
Model	DR-BT20NX
Category	Headsets
Language	English