41
Playback
Chapter 2 Recording and Playback
Playback Procedure
Note
When controlling this unit from an editing control unit connected to the
REMOTE connector of this unit, set the LOCAL/REMOTE switch of this unit
to REMOTE, turning the REMOTE indicator on. When not, set the switch to
LOCAL, turning the indicator off.
1
Insert a cassette.
For details of cassette insertion see page 31, and for usable cassette types
see page 29.
The cassette is automatically drawn into the unit and the STOP button
lights. A few seconds later, if the STOP menu item under the AUTO EE
SELECT menu item (see page 67) is set to PB, a still image will appear on
the monitor screen.
2
Press the PLAY button.
This starts the playback operation. When the tape is played back all the way
to the end, the unit automatically rewinds it and then stops.
If the following indicators light when a cassette is loaded
Indicator It means:
Cassette memory indicator The loaded cassette contains a cassette memory.
CL indicator There is ClipLink log data stored in the cassette
memory on the loaded cassette.
NO EDIT indicator • The tape was recorded in the DV format, or a
DVCPRO tape is inserted.
You cannot use it as a recording tape for editing.
• The recording format selected on this unit is DV
(SP).
2
1
REW PLAY F FWD STOP REC
INPUT
VIDEO
AUDIO
V:SDTI
SDTI
i.LINK
SDI SG
SDI SG SDI SG
ANALOG
CH-1 1/2
AES/EBU
dB
0
-12
-20
-30
-40
-60
OVER
2 4
CH-
dB
0
-12
-20
-30
-40
-60
OVER
1 3
CH-
OUTPUT
VIDEO
AUDIO
HOURS MINUTES SECONDS FRAMES
SDI
SDTI
COMPOSITE
S VIDEO
Y-R,B
COMPOSITE
S VIDEO
Y-R,B
CH 1/2
CH 3/4
PB FS
48K 44.1K 32K
U-BIT
TC NO
CL
EDIT
REC INHI
REPEATCOUNTER
SERVO
REC MODE
2CH 4CH
VITC
EDIT MODE
REMOTE
9P i.LINK
ANALOG
CH-2 3/4
AES/EBU
LOCAL/
REMOTE switch
To Next Page
Loading...
Need help?
General
