To make audio recordings with the connected computer or smartphone
You can connect the receiver to a computer or a smartphone for audio recording as well.
For details about connecting the devices, see Connecting the receiver to a computer or a smartphone.
Note
When you are finished with using the receiver and the microphone, be sure to turn them off.
Depending on the using condition, an analog connection with this unit may cause noises to be included in audio recordings.
To use a camera compatible with the digital audio interface of the Multi Interface Shoe or a device with a USB audio input
capability, make a digital connection with the receiver and the microphone. When a radio device is nearby, keep them sufficiently
away from the device.
While video recording is in progress, changing the receiver mode with the mode switch may cause a failure in switching the
receiver mode, a failure in audio recording due to disconnected communication, or noises in the recording. Before selecting a
receiver mode with the mode switch, be sure to stop the recording. (ECM-W3)
While video recording is in progress, operating the ATT switch or the filter switch on the microphone may cause operation sounds
to be included in the recording. Before changing the switch setting, be sure to stop the recording.
When a video recording is made with the receiver and the microphone, an operation sound (an electronic sound) may be
included at the beginning of the recording. It is recommended that you disable the operation sound settings on your camera
before making video recordings. For details, refer to the operating instructions of your camera.
The receiver receives power supply from the camera as well. (The built-in battery of the receiver, however, is not charged with the
supplied power.) Depending on your camera, however, it may not be capable of supplying power. For the camera models that
support power supply to the receiver, visit our website at:
ECM-W3
https://www.sony.net/dics/ecmw3/
ECM-W3S
https://www.sony.net/dics/ecmw3s/
Related Topic
About the mode switch (ECM-W3)
Lamp indications
5-055-395-11(1) Copyright 2023 Sony Corporation
Make sure that the LINK lamp on the receiver is lit in blue, and then start video recording with the camera.
3
To Next Page
Loading...
Need help?
General
