539
Saving and Loading a File
For a newly created file, if you create a directory on a
removable drive and move the file to the prescribed
location, you can then load the file using File >All,
External File >All menu (7161).
When modifying a file saved on the switcher, be sure to
save it in the original directory.
Example path:
Removable Drive\Sample\MACRO\CTRLCPU\
nnnnnnnn.PNL_rrrr.PMR
Errors
If any of the following problems occur, it is not possible to
load the file. Attempting to load the file will produce an
error message.
• If there is a syntax error.
• If a required parameter is not present.
For details, see “Error Messages” (page 554).
Correspondence Between Events and Symbols
For details about events, see “Events” (page 346).
Note
Removable drive Any directory
MACRO
CTRLCPU
nnnnnnnn.PNL_rrrr.PMR
Event Symbol Using Continue
Cross-point selection in the AUX bus control block (AUX bus operation mode) AuxXpt No
Cross-point selection in the AUX bus control block (router operation mode) RouterXpt Yes
Cross-point selection in the cross-point control block MEXpt Yes
Auto transition and take in the transition control block MEAutoTransition Yes
Cut in the transition control block MECut No
Transition type selection TransitionType No
Next transition setting NextTransition No
Pattern limit enable/disable PatternLimit No
Execution of fade to black FadeToBlack No
Auto transition in an independent key transition KeyAutoTransition Yes
Key insertion and removal in an independent key transition KeyCut Yes
Independent key transition type selection KeyTransitionType No
VTR/disk recorder/frame memory clip start point setting StartTc Yes
VTR/disk recorder/frame memory clip playback Play Yes
VTR/disk recorder/frame memory clip stop Stop Yes
VTR/disk recorder/frame memory clip cue-up Cue Yes
VTR/disk recorder/frame memory clip fast forward FF Yes
VTR/disk recorder/frame memory clip rewind Rewind Yes
To Next Page
Loading...
Need help?
General
