8
GB
Getting Started
Installing the
Batteries
Slide open the battery
compartment lid and insert two
R6 (size AA) batteries (not
supplied). Be sure to match up the
+ and – indications on the
batteries with the + and –
indications on the battery
compartment.
When to replace the
batteries
Batteries for remote control
operation (two R6 (size AA)
batteries)
Under normal conditions, the
batteries will last up to six
months. If the Commander does
not operate properly, the batteries
might be drained. When this
happens, replace the batteries with
new ones.
Note
Do not take more than one hour to
replace the batteries. Otherwise, your
code number settings (page 10) and
“learned” remote control signals (page
16) will be erased.
Notes on batteries
• Do not use an old battery with a new
one, or mix different types of
batteries together.
• If the electrolyte inside the battery
should leak, wipe the contaminated
area of the battery compartment with
a cloth and replace the old batteries
with new ones. To prevent electrolyte
from leaking, remove the batteries if
you plan not to use the Commander
for a long period of time.
Insert the batteries (negative end
first) through the guide clamp
within each compartment as
shown above.
To Next Page
Loading...
Need help?
General
