Check the following before operating the unit.
- This unit
is
connected to a power source and the
c9
indicator (green) goes off.
1 Press and hold the
10
SET button for 7 seconds or more.
When
theC)
indicator (green) and 0 indicator (blue) start flashing together, release the
button. This unit enters pairing mode.
Note
Pairing mode is canceled and this unit is turned
off
after about 5 minutes.
If
this unit is turned
off
while performing the procedure, start over from step 1.
2 Perform pairing procedure on the BLUETOOTH stereo audio source
device to detect this unit.
The list
of
detected devices appear on the display
of
the BLUETOOTH stereo audio
source device.
This unit is displayed as "SRS-BTM30."
If
"SRS-BTM30" is not displayed, repeat from step 1.
Notes
• When pairing, be sure to place both the BLUETOOTH devices within 1
ill
(3 ft)
of
each other.
• Some devices cannot display the list
of
detected devices.
3 Select "SRS-BTM30" shown
in
the display of the BLUETOOTH stereo
audio source device.
4 If Passcode* input is required on the display of the BLUETOOTH stereo
audio source device, input "0000."
* Passcode may be called "Passkey," "PIN code," "PIN number," or "Password."
5 Start the BLUETOOTH connection from the BLUETOOTH device.
Some BLUETOOTH stereo audio source devices may connect with the unit
automatically when pairing is complete.
When the BLUETOOTH connection is made properly, both the
C)
indicator (green)
and 0 indicator (blue) light up indicating that pairing is complete, and pairing
information is memorized on this unit.
Note
If
you tum
off
this unit
or
the BLUETOOTH stereo audio source device before the BLUETOOTH
connection is complete, pairing information is not memorized and pairing will not be completed.
Continued
11
us
To Next Page
Loading...
Need help?
General
