EN
12
Problem Possible Cause Solution
Aircraft
will not
respond to
throttle but
responds
to other
controls
Throttle not at idle and/or
throttle trim too high
Reset controls with throttle
stick and throttle trim at low-
est setting
Throttle servo travel is lower
than 100%
Make sure throttle servo travel
is 100% or greater
Throttle channel is reversed
(With battery disconnected
from aircraft) Reverse throttle
channel on transmitter
Motor disconnected from
ESC
Make sure motor is connected
to the ESC
Aircraft will
not Bind
(during
binding) to
transmitter
Transmitter too near aircraft
during binding process
Move powered transmitter a
few feet from aircraft, discon-
nect and reconnect flight bat-
tery to aircraft
Aircraft or transmitter is too
close to large metal
object, wireless source or
another transmitter
Move aircraft and transmitter
to another location and at-
tempt binding again
The bind plug is not in-
stalled correctly in the bind
port
Install bind plug in bind port
and bind the aircraft to the
transmitter
Flight battery/transmitter
battery charge is too low
Replace/recharge batteries
Bind button not held long
enough during bind process
Power off and repeat bind
process.
Troubleshooting Guide
To Next Page
Loading...
Need help?
General