STERWINS 150C EPW.4 User Manual

Assembly
WARNING!
All assembly operations must be performed with the appliance disconnected
from the mains power supply.
The assembly sequence is illustrated in the characteristics manual. Pls refer to
the content to do the assembly job.
WARNING!
Wear suitable clothing, ears and eyes protecting when working with the
equipment. Ensure that the equipment is functional before each use. Ensure
that the mains voltage value matches the label on the equipment. The appliance
should only be connected to a mains power supply equipped with an adequate
earth connection and a dierential security breaker (30mA) to cut o the
electricity supply in the instance of a short circuit.
Check the safe condition of the machine:
– Check it for visual defects.
– Check that all parts of the machine have been securely tted.
– Check if the water connector and the high-pressure pipes are tight.
Starting and stopping
Note: put the high pressure washer on a smooth ground. Stand in a secure and stable position.
Starting:
i. Open the water inlet valve
ii. Press the safety button on the spray gun, and press the trigger until there is a steady
stream of water.
iii. To switch the machine on, set the On(1)/O(0) switch to ON(1)
Stopping:
iv. Release the trigger
v. To switch the machine o, set the On(1)/O(0) switch to OFF(0).
vi. Close the water inlet valve
Attention!
Risk of machine damage!
Never operate the machine without water inlet as dry running may damage the pump. Use a
water lter if the inlet water is contaminated.
5. OPERATION
153
EN

STERWINS 150C EPW.4 Specifications

General

Brand	STERWINS
Model	150C EPW.4
Category	Pressure Washer
Language	English