34
ENGLISH
EN
5. Remove the screw (12:E) with nut and undo the
screw (12:F) so that both wheels rest against the
ground.
6. Install screw (12:E) in the holes that correspond
best and tighten the screw (12:F).
7. Install the deck on the machine.
7.4 WEAR PROTECTION
There are two wear protection devices on the un-
derside of the cutting deck to protect it. These can
be replaced if necessary.
8 SPARE PARTS
STIGA genuine spare parts and accessories are de-
signed specifically for STIGA machines. Please
note that ‘non-genuine’ spare parts and accessories
have not been checked or approved by STIGA:
The use of such parts and accessories
can affect the function and safety of the
machine. STIGA accepts no responsi-
bility for damage or injuries caused by
such products.
9 DESIGN REGISTRATION
This product or parts thereof is covered by the fol-
lowing design registration:
Sweden: 66 166
Germany: 499 11 740.9
France: 577 251-253, 577 439-443
USA: 435 564
GGP reserves the right to make alterations to the
product without prior notification.
To Next Page
Loading...
Need help?
General
