6
ting devices or ones homologated by the
Manufacturer.
job to be done, according to these general indi-
cations:
– the 3-point blade is suitable for cutting brush-
– the 4-point blade is suitable for cutting tough
grass over large surfaces;
– the cutting line head
-
den;
–
felled.
-
IMPORTANT The cutting devices are fastened
with a left-hand thread and therefore must be un-
screwed clockwise and screwed on anticlock-
wise. Remove all elements that may have been
assembled, which will be used in various con-
figurations, according to the cutting device used.
(Fig. 6)
– Fit the inner ring-nut (1) in the indicated di-
-
-
-
-
(9).
-
the cup (6).
blade (3) and the inner ring-nut.
– Fit the inner ring-nut (1) in the indicated di-
-
-
ic hole of the inner ring-nut (1), then turn the
-
– Fit the additional guard (8), inserting the cou-
plers into the respective seats in the guard (9)
WARNING! When using the cutting line
head, the additional guard, with line cutting
knife, must always be fitted.
hole of the inner ring-nut, then turn the ring-nut
-
ing rotation.
– Fit the inner ring-nut (1) in the indicated direc-
-
–
-
-
To Next Page
Loading...
Need help?
General
