Stiga SHT 500 User Manual

WARNING! Mount the components ve-
ry carefully so as not to impair the safety and
eciency of the machine. If in doubt, contact
your dealer.
WARNING! Make sure the machine is
not plugged into the mains socket.
WARNING! Unpacking and complet-
ing the assembly should be done on a at and
stable surface, with enough space for moving
the machine and its packaging, always mak-
ing use of suitable equipment.
Disposal of the packaging should be done in ac-
cordance with the local regulations in force.
1. MOUNTING THE FRONT GUARD
(If supplied separately) - (Fig.1)
– Position the front guard (1) on the end section
of the power unit (2).
– Secure the guard using the two screws (3).
6 MACHINE ASSEMBLY / PREPARING TO WORK
EN
1. CHECKING THE MACHINE
WARNING! Make sure the machine is
not plugged into the mains socket.
Before starting work please:
– check that the mains frequency and voltage is
the same as the rating data on the “Identication
Plate” (see chap. 1 - 8.8).
– check that the trigger switches and the safety
switch should move freely without forcing and
return automatically and rapidly back to their
neutral position;
– check that the cooling air vents are not ob-
structed;
– check that the power cable and extension lead
are not damaged;
– check that handgrips and protection devices
are clean and dry, correctly mounted and well
fastened to the machine;
– check that the cutting devices and guards are
not damaged;
– check that the machine is not showing signs of
wear or damage due to knocks or other causes,
and carry out the necessary repairs.
2. ELECTRICAL CONNECTIONS
WARNING! Electricity and moisture
are not compatible.
– Always handle and connect electric cables
in dry conditions.
– Keep electric sockets or cables away from
wet and damp areas (e.g. puddles or wet
ground).
– Power the machine using a residual current
device (RCD Residual Current Device) with
max. 30 mA tripping current.
The quality of the extension leads must be no less
than H07RN-F or H07VV-F, with a minimum sec-
tion of 1.5 mm and a recommended maximum
length of 30 m.
To avoid overheating, do not keep the extension
lead rolled up during use.
WARNING!
NOTE
The perma-
nent connection of any electrical equipment
to the mains of a building must be installed by
a qualied electrician in conformity with the
regulations in force. Incorrect wiring can
cause serious injury and even death.
4. MACHINE ASSEMBLY
5. PREPARING TO WORK
All manuals and user guides at all-guides.com
all-guides.com

Stiga SHT 500 Specifications

General

Brand	Stiga
Model	SHT 500
Category	Trimmer
Language	English