EasyManua.ls Logo

Stiga VILLA 320 - 2.4 MAINTENANCE AND STORAGE

Stiga VILLA 320
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
68
ENGLISH
EN
Original instructions for use
a. To remove sticks and rubbish or when the dis-
charge has become clogged.
b. To check, clean or service the machine.
c. To check whether damage has occurred and
to carry out any repairs before starting and us-
ing the machine again after a collision with a
foreign object.
d. To check the machine if it begins to vibrate
excessively. (Check immediately).
Disengage the drive to accessories during trans-
port or when the machine is not in use.
Shut off the engine and disconnect the drive to
the accessories:
a. Before filling with petrol.
b. Before removing the grass collector.
c. Before adjusting the height setting, assuming
this cannot be done from the drivers position.
Reduce the throttle when the engine is to be
stopped
Take care with multiple blade decks as one ro-
tating blade can cause other blades to rotate.
The machine, equipped with original accesso-
ries, must not be driven in any direction on
slopes with a gradient greater than 10º.
The cutting deck’s original blade(s) may not be
replaced with non-original devices intended for
e.g. moss scarification. If such devices are used,
the guarantee will cease to be valid. There is
also a risk of serious injury or damage to people
or property.
Take care when unloading and loading the ma-
chine onto a trailer or lorry.
During transport on lorry or trailer the parking
break must always be activated.
During transport on lorry or trailer the clutch re-
lease lever must be pushed in. See 5.4.10.
During transport always make sure the machine
is secured to the trailer or lorry according to lo-
cal laws and regulations.
2.4 MAINTENANCE AND STORAGE
Tighten all nuts and screws so that the machine
is in safe working condition.
At regular intervals check that the cutting
deck’
s blade screw(s) are properly tightened.
Regularly check the operation of the brakes. It
is important to maintain and repair the brakes if
necessary.
Never store the machine with petrol in the tank
in buildings where the fumes can come into
contact with open flames or sparks.
Allow the engine to cool before placing the ma-
chine in a store.
Check frequently whether there is any wear or
damage to the grass collector.
For the sake of safety, replace worn or damaged
parts.
Always use genuine spare parts. Non-genuine
spare parts can entail a risk of injury, even if
they fit the machine.
Replace damaged warning and instruction
stickers.
If there is no mechanical lock for the transport
position, the cutting deck must be lowered
when parked, stored or when the machine is left
unsupervised.
If the petrol tank is to be emptied, this must take
place outdoors.
Store the machine so that children cannot get to
it.
The battery contains acid. In the event of me-
chanical damage or overcharging, acid can leak
out.
Never overcharge the battery. Overcharging can
cause the battery to explode, throwing the acid
in all directions.
If acid comes into contact with the eyes or skin,
this can cause serious injuries. If any part of the
body has come into contact with acid, rinse im-
mediately with copious amounts of water and
seek medical assistance as soon as possible.
Fumes from acid that are inhaled cause damage
to mucous membranes and other internal or-
gans. Seek medical assistance if acid fumes
have been inhaled.
Acid causes serious damage to tools, clothes
and other material. Rinse away spilled acid im-
mediately with water.

Related product manuals