0458-511-8621-C
8
English
8 LED DIAGNOSTICS
7.3 Mounting the Charger on a Wall
When mounting, ensure that no electrical cables, pipes or
other service lines run in the wall behind the charger.
To mount the wall charger:
► Mount the charger indoors in a dry room near a wall outlet.
► Sink the screws into a wall stud. Use appropriate screw-in
wall anchors or other similar mounting devices if an
appropriate wall stud is not available.
► Align the charger as shown above. Mount to a wall with the
following dimensions:
– a = minimum 3.9 in. (100 mm)
– b (for AL 101) = 3.0 in. (75 mm)
– b (for AL 300 and AL 500) = 4.7 in. (120 mm)
– c = 0.2 in. (4,5 mm)
– d = 0.4 in. (9 mm)
– e = 0.1 in. (2,5 mm)
8.1 LED on the Charger
One LED shows the status of the charger. The LED can glow
green or flash red.
For more information, @ 11.
9.1 Storing the Charger
WARNING
Store the charger indoors in a dry, secure place that is
inaccessible to children and other unauthorized users.
Improper storage can result in unauthorized use and
damage to the charger that can lead to fire and explosion,
and otherwise increase the risk of severe personal injury
and property damage, @ 6. Never store the battery in the
charger, @ 6.
8 LED DIAGNOSTICS
d
a
1
2
0000-GXX-0609-A0
a
e
e
b
3
If the LED glows green continuously: the battery
is being charged.
or
The battery is too hot or too cold for charging. To
determine, check the LEDs on the battery. If
there is one glowing red light, allow the battery to
warm up or cool down gradually at an ambient
temperature of about 50 °F to 68 °F (10 °C to
20 °C).
If the LED flashes red: there is no electric contact
between the battery and the charger. Remove
and reinsert the battery.
or
The battery has a malfunction and must be
replaced. Check the LEDs on the battery. Do not
use or charge a battery if its LEDs indicate a
malfunction.
or
The charger has a malfunction. Have it checked
by an authorized STIHL servicing dealer before
use.
9 STORING
To Next Page
Loading...
Need help?
General
