Stihl BR 450 C User Manual

BR 450, BR 450 C
English
14
Removing the nozzle (BR 700 X)
N Rotate the nozzle (1) in the direction
of arrow as far as the stop.
N Pull the nozzle (1) off the blower
tube (2).
Adjusting the Blower Tube (BR 700)
N Loosen the union nut (1).
N Pull the blower tube (2) out to the
required length.
N Tighten the union nut (1).
Wear Mark on Nozzle
The front end of the nozzle wears away
due to abrasive ground contact during
operation. The nozzle is subject to
normal wear and tear and must be
replaced when the wear mark is
reached.
Transport Aid
When storing or transporting the
machine:
N Secure the blower tube to the
handle on the backplate with the
hook and loop fastener.
It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
N Set the throttle trigger to the full
throttle position.
N Carefully rotate the screw in the
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another half turn in the
same direction.
1
2
0000-GXX-3990-A0
1
0416BA015 KN
2
0416BA009 KN
Adjusting the Throttle Cable
002BA655 KN
Downloaded from ManualsNet.com search engine

Stihl BR 450 C Specifications

General

Brand	Stihl
Model	BR 450 C
Category	Blower
Language	English