–
Vibration level a
hv
measured according to
ISO 22867:
–
Control handle: 2.6 m/s².
–
Left handle: 2.5 m/s².
For information on compliance with Employers'
Vibration Directive 2002/44/EC, see
www.stihl.com/vib.
19.4 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
19.5 Exhaust Emissions
The CO
2
value measured in the EU type approval
procedure is specified at www.stihl.com/co2.
The measured CO
2
value was determined on a
representative engine in accordance with a
standardized test procedure under laboratory
conditions and does not represent either an
explicit or implied guarantee of the performance
of a specific engine.
The applicable exhaust emission requirements
are fulfilled by the intended usage and mainte‐
nance described in this instruction manual. The
type approval expires if the engine is modified in
any way.
20 Combinations of Cutting Attachments, Deflectors and Carrying
Systems
20.1 Combinations of Cutting Attachments, Deflectors and Carrying Systems
Cutting attachment Deflector Carrying System
–
AutoCut 46-2 mowing head
–
DuroCut 40-4 mowing head
–
SuperCut 40-2 mowing head
–
TrimCut C 42-2 mowing head
–
Guard for mowing heads
–
Universal deflector with skirt and line lim‐
iting blade
–
Full harness with
quick-release sys‐
tem
–
Grass cutting blade 230-4
(230 mm dia.)
–
250-32 Grass cutting blade
(250 mm dia.)
–
Grass cutting blade 250-40
"Special" (250 mm dia.)
–
255-8 Grass cutting blade
(255 mm dia.)
–
Universal deflector without skirt
–
Brush knife 300-3 (300 mm
dia.)
–
Brush knife 305-2 "Special"
(305 mm dia.)
–
Universal deflector without skirt
–
Shredder blade 270-2
(270 mm dia.)
–
Shredder blade deflector
–
Circular saw blade 200-22,
chisel tooth (4119) (200 mm
dia.)
–
Circular saw blade 200-22,
chisel tooth HP (4000)
(200 mm dia.)
–
Circular saw blade 200-44,
scratcher tooth (200 mm dia.)
–
Limit stop with 200 mm diameter
–
Circular saw blade 225-48,
scratcher tooth (225 mm dia.)
–
225-24 circular saw blade,
chisel tooth (225 mm dia.)
–
HP chisel tooth 225-22 circular
saw blade (225 mm dia.)
–
225-36 circular saw blade, car‐
bide (225 mm dia.)
–
Limit stop with 225 mm diameter
English 20 Combinations of Cutting Attachments, Deflectors and Carrying Systems
22 0458-841-0101-A
To Next Page
Need help?
General
